125986421_gb.qxp
2007-09-14
Malfunction
When pressing a button, the
corresponding button flashes
several times.
Drum light does not
work
Drying cycle ends
shortly after programme
starts. END light illuminated.
Drying cycle lasts an
unusually long time.
Note:
After around 5 hours
the drying cycle ends
automatically (see
„Drying cycle complete")
When a button is pressed, Err
appears in the multi-display.
If you are unable to identify or solve the
problem, contact our service centre.
Before telephoning, make a note of the
model, serial number and purchase date
of your machine: the Service Centre will
require this information.
09:11
Page 21
something not working electrolux 21
Possible cause
Washing protection. After the
●
start of the programme, the
option can no longer be set.
Programme selector in OFF
●
position.
Defective light bulb
●
Not enough washing loaded
●
or washing loaded is too
dry for selected programme.
Lint filter clogged.
●
button pressed and load
●
volume too big.
Load volume too big.
●
Laundry insufficiently
●
predrained.
Washing protection. After the
●
start of the programme, the
option can no longer be set.
IMPORTANT: if you call out an engineer
to a fault listed below, or to repair a fault
caused by incorrect use or installation, a
charge will be made even if the
appliance is under guarantee.
Solution
Turn the programme knob to
●
OFF. Set the programme
again
Turn programme selector to
●
any programme
Replace light bulb (see next
●
section).
Select time programme or
●
higher drying level (e.g. EXTRA
DRY instead of STRONG).
Clean lint filter
●
is only suitable for use
●
with loads of up to 3 kg!
Reduce load volume.
●
Laundry must be adequately
●
pre-drained.
Turn the programme knob to
●
OFF. Set the programme again.
GB