HP D7171A - NetServer - LPr Frequently Asked Questions page 3

A3. Dual RJ-45 LAN connector and two LEDs to indicate LAN speed and link
Serial Port A
Embedded Remote Management Port or Serial Port B
Parallel Port (ECP/EPP)
Mouse Port
Keyboard Port
USB ports
Monitor Port (SVGA)
Power Connector
External SCSI port
Q4. What IDE devices come bundled in the NetServer lp 1000r?
The NetServer lp 1000r comes bundled with a slim IDE CD-ROM drive. IDE hard drives are
A4.
not supported on lp 1000r.
How many channels are on the embedded Ultra 3 SCSI controller?
Q5.
A5. The Ultra 3 SCSI controller in the NetServer lp 1000r has two channels. Both Channel A and
Channel B have cables attached to them. Channel B is used to connect to external port to an
external mass storage solution. Channel A is connected to the Hot Swap hard disk cage.
Q6. Are there any common tray internal devices support on the netserver lp 1000r?
A6. No common tray internal devices supported on lp 1000r
Q7. What type of SCSI controller is embedded on the system board of the NetServer lp 1000r?
The NetServer lp 1000r has an embedded dual-channel Ultra 3 Wide PCI SCSI controller.
A7.
Channel A is used for cabling the to hot swap hard disk cage. Channel B is connected to an
external port for external SCSI devices.
What is the boot priority for bootable devices in the NetServer lp 1000r?
Q8.
1. IDE CDROM Drive
A8.
2. Floppy Disk Drive
3. Embedded SCSI A
4. Embedded SCSI B
5. PCI
6. Network Connection
Q9. What is the kind of memory is used in the lp 1000r? What is the maximum memory
configuration in the lp 1000r?
A9. The lp 1000r uses ECC memory; 72 bit wide, 168-pin PC 133Mhz SDRAM HP DIMMs. lp
1000r has 4 DIMM slots. The lp 1000r ships with HP 256MB (D8265A) and also supports
128MB (D8265A), 512MB (D8267A) and 1GB (D8268A). The maximum memory
configuration is 4 GB. (4 x D8268A). Use of HP memory is strongly recommended.
Describe the internal mass storage configuration options?
Q10.