HP D7171A - NetServer - LPr Notice page 6

<Enter>
8. CD-ROM initialization message—brief pause
9. "Installation Path"
---> Install
<Enter>
10. "Installation Class"
---> Custom
<Tab> to "OK" <Enter>
NOTE "Server" and "Workstation" classes may be more limited in
flexibility than is "Custom".
11. "SCSI"—message (such as "Scanning NCR 538xx") for LPr or ("Scanning Adaptec
2740,2840,2940") for LC3 and brief pause
12. "SCSI Configuration"—showing "NCR 538xx" for LPr and showing" Adaptec 2740,
2840, 2940 " for LC3 (the Linux device scan automatically detects this) and asking
whether you want to check for others.
<Tab> to "No" <Enter>
13. "Disk Setup"
NOTE You may use either fdisk or Disk Druid to create partitions on
your hard disk. Using Disk Druid is somewhat easier, but may
involve some trial and error repetition. Before using fdisk, you
must erase the master boot record. An example of using fdisk is
illustrated in Appendix B.
Use Disk Druid or fdisk to set up your partitions now.
Continuing the Linux Installation
NOTE The following discussion assumes you have sda1 as the Linux
Native partition and sda2 as the Linux Swap partition.
14. "Partition Disks"
<Tab> to "Done" <Enter>
15. A screen appears showing information about your choices on disk partitioning. From
this screen, you need to indicate where the root filesystem will be located. To begin
the edit, press
6