HP D7171A - NetServer - LPr Manual page 19

Chapter 2
4. Reattach the rear access panel.
a. Lower the panel into place. A slotted flange extends from the top of
the panel on either side. Lower the slots over the matching tabs on the
satellite chassis.
b. Tighten the three captive screws.
5. Reattach the lower fan module:
a. On each side of the back of the fan module are two slots. Line these
slots up with the flanges on the fan's mounting rails.
b. Push the fan module onto the mounting rails until it clicks into place.
6. Reattach the satellite chassis to the base chassis:
a. When you finish servicing the HP NetServer, move to the front of the
server and unlatch all four power supplies. (If the front bezel is in
place, remove it.)
b. At the rear, insert the satellite chassis. To do so, push in the release
latch for each slide (Figure 2-9). While holding the latches down, push
the satellite part way onto the base, so that the latches can no longer
engage.
Installing the SCSI Extender
15