Chapter 6.System Compatibility; Hardware Compatibility; Hardware Interrupts - IBM NetVista X40 Technical Information Manual

Chapter 6. System compatibility

Hardware compatibility

Hardware interrupts

© Copyright IBM Corp. 2000
This chapter discusses some of the hardware, software, and BIOS compatibility issues
for the computer. See the Compatibility Report under, "Related publications" on page
vii for a list of compatible hardware and software options.
This section discusses hardware, software, and BIOS compatibility that must be
considered when designing application programs.
The functional interfaces are compatible with the following interfaces:
• Intel 8259 interrupt controllers (edge-triggered mode)
• Motorola MC146818 Time of Day Clock command and status (CMOS
reorganized)
• Intel 8254 timer, driven from a 1.193 MHz clock (channels 0, 1, and 2)
• Intel 8237 DMA controller, except for the Command and Request registers and
the Rotate and Mask functions; the Mode register is partially supported
• Intel 8272 or 82077 diskette drive controllers
• Intel 8042 keyboard controller at address hex 0060 and hex 0064
• All video standards using VGA, EGA, CGA, MDA, and Hercules modes
Use this information to develop application programs. Whenever possible, use the
BIOS as an interface to hardware to provide maximum compatibility and portability
of applications among systems.
Hardware interrupts are level-sensitive for PCI interrupts. The interrupt controller
clears its in-service register bit when the interrupt routine sends and End-of-Interrupt
(EOI) command to the controller. The EOI command is sent regardless of whether the
incoming interrupt request to the controller is active or inactive.
The interrupt-in-progress latch is readable at an I/O-address bit position. This latch is
read during the interrupt service routine and might be reset by the read operation or it
might require an explicit reset.
Note: For performance and latency considerations, designers might want to limit
the number of devices sharing an interrupt level.
With level-sensitive interrupts, the interrupt controller requires that the interrupt
request be inactive at the time the EOI command is sent; otherwise, a new interrupt
request will be detected. To avoid this, a level-sensitive interrupt handler must clear
the interrupt condition (usually by a read or write operation to an I/O port on the
device causing the interrupt). After processing the interrupt, the interrupt handler:
1. Clears the interrupt
2. Waits one I/O delay
3. Sends the EOI
4. Waits one I/O delay
5. Enables the interrupt through the Set Interrupt Enable Flag command
19