Image Adjustment - Sanyo XU88 - PLC XGA LCD Projector Owner's Manual

Chapter 7 Controlling the projector

Image adjustment

This function is to adjust the projected picture image and save the image mode. To store the adjusted
value, click Store button, and to load the adjusted value, click Load button.
Input source
Image mode Video
Dynamic
Standard
Real
Cinema
Blackboard(Green) 4
Image 1 - 4
68
Item
Contrast.....................Adjusts picture contrast
Brightness ................Adjusts picture brightness
Color ...........................Adjusts picture color saturation
Tint ..............................Adjusts picture hue
Item
Color Temp. .............. Sets a color temperature mode.
White Balance
Red, Green,
Blue ...................... Adjusts each white balance respectively.
Sharpness .................Adjusts picture sharpness.
* When the value of the white balance is changed, the color temp.
indicates "Adj."
Item
Gamma ........................ Adjusts brightness of darker part of the picture.
Noise reduction ....... Switches noise reduction mode
Progressive scan ......... Switches progressive mode
Reset ...........................Resets the Image adjustment to previous levels.
Store ........................... Stores the Image adjustment values. Select an item
Load ............................ Loads the Image mode. Se-
Computer
4 4
4 4
*
4
*
4
✐ The mark "4" indicates the available image mode in the selected
4
4 4
Description
Description
Description
[Image 1 - Image 4] from the pull-down menu and click
Store button.
lect an image mode from the
pull-down menu and click
Load button. There may not
be available mode depend-
ing on the input mode as
shown in the table left.
input source. The error message appears when the disabled
image mode indicated with "*" is selected.