Sanyo XU88 - PLC XGA LCD Projector Owner's Manual page 65

Instruction manual, plc-xu88 network set up
Hide thumbs Also See for XU88 - PLC XGA LCD Projector:
Table of Contents

Advertisement

About projector condition
Status
Normal ..................................................................Projector is operating normally.
Power management in operation ......................Power management is operating
Lamp failure........................................................Lamp failure is occurring
Abnormal Temperature ..................................The temperature of the projector became too high
Cooling down after abnormal Temp.
Standby after Abnormal Temp. ................... Projector detects abnormal temp. and is set into standby mode.
Power failure ..................................................... Power failure has occurred inside the projector. Projector is turned off.
When a security (PIN code lock) has been set on the projector, you also cannot control it through the
network. To control the projector through the network, unlock the security on the projector using
with the projector's menu control.
Caution about turning on/off the projector via the networks
When turning on/off the projector via the networks, preset the projector as follows:
1. Select "Setting" from the Projector menu.
2. Select "Standby mode" from the Setting menu and set it as "Normal".
If you set this function as Normal, the network part of the projector is constantly provided with
power even if the projector is turned off. If you set this as Eco, then the network part will be turned
off when you turn off the projector. Consequently, you cannot turn on/off the projector via the
networks.
Description
Projector detects abnormal temp. and is cooling down itself.
Unplug the AC cord and contact a qualified service personnel for service.
If the power failure occurs on the projector, "Power failure" is indicated on
the status column and the information icon appears on the power column
as shown below. Click this icon to display further information of the power
failure.
Click this icon to display
further information of
the power failure.
Power control and status check
65

Advertisement

Table of Contents
loading

This manual is also suitable for:

Plc-wxu30a - 3700 lumensXu88

Table of Contents