Equipment Noise; Service Clearance, Floor Cutout, And Floor Load Rating; Single Rack Configuration - HP P9000 Manual

Site preparation guide
Hide thumbs Also See for P9000:
Table of Contents

Advertisement

Table 12 Heat, power, and airflow (continued)
Model Number
AV490A - HP P9500 200GB
SAS 2.5in DP SSD
Notes:
1: Maximum values in case the all fans rotate at maximum.
2: Power is consumed during the battery back-up time only.
3: Actual values at a typical I/O condition. (Random Read and Write, 50 IOPSs for HDD, 2500 IOPSs for SSD, Data
Length: 8Kbytes). These values may increase for future compatible drives.

Equipment noise

The acoustic emission values [loudness in dB (A)] for the P9500 disk array disk array are:
Front/rear = 65 dB (A)
Both sides = 65 dB (A)

Service clearance, floor cutout, and floor load rating

This section describes the service clearance requirements for the P9500 disk array, based on the
floor load rating and the clearance and required floor cutouts for cabling. The figures and tables
that provide this information are listed in the following table.
Table 13 Service clearance and floor load ratings
Service Clearance and Floor Load Rating
Number of racks
1
2
2 (two DKC)
3 (left module)
3 (right module)
4 (left module)
4 (right module)
5
6
NOTE:
For safe and efficient maintenance operations, clearance (c) should be made as large
as possible. Actual clearances for installation should be determined after consulting with the
site/facilities manager, as the clearances can vary, depending on building conditions. Although
all disk chassis come pre-installed, up to 1420mm of clearance may be required at both front and
back for a disk chassis replacement.
The figures in this section are not drawn to scale.

Single rack configuration

The following figure and table show the service clearances and floor load rating for a single rack
configuration.
22
Installation requirements
Heat Output (kW)
3
0.0127
Section
"Single rack configuration" (page 22)
"Two rack configuration (one DKC)" (page 24)
"Two rack configuration (two DKC)" (page 26)
"Three rack configuration (left module)" (page 28)
"Three rack configuration (right module)" (page 30)
"Four rack configuration (left module)" (page 32)
"Four rack configuration (right module)" (page 34)
"Five rack configuration" (page 36)
"Six rack configuration" (page 38)
Power Consumption (kVA)
3
0.0134
Air Flow (M3/min)
-

Advertisement

Table of Contents
loading

This manual is also suitable for:

Xp p9500Storageworks p9500

Table of Contents