Fcu Error Codes For Unix - HP StorageWorks P9000 User Manual

FCU Error Codes for UNIX

If the FCU for UNIX reports an error, use the Help-Error command to view the most recent error.
66 on page 154 lists and describes the FCU error codes for UNIX and provides instructions for resolving
each error condition. In
be reported when I/O access contention for the Data Exchange volume occurs between the mainframe
and open-system hosts. If the cause of the error cannot be identified as described in
66 on page 154, check for any illegal I/O contention for the Data Exchange volume.
NOTE:
Error codes with a negative value are FCU errors. Error codes with a positive value are system errors.
UNIX system error codes are defined in the standard error file errno.h.
NOTE:
The error codes with (C) in the Error code cell in
with Data Exchange Code Converter. For details, see the HP StorageWorks Data Exchange Code
Converter User's Guide .
Table 66 FCU Error Codes for UNIX
Error
Code
No parameter file
-100
Parameter file: Open error
-101*
Parameter file: Read error
-102*
Parameter file: No valid data
-103*
Parameter file: CODE_CONV error
-107
154 Troubleshooting
Table 66 on page 154, the error codes marked by an asterisk (*) may also
Error Message and Description
The FCU parameter definition file could
not be found.
An error occurred when opening the
parameter definition file.
An error occurred when reading the
parameter definition file.
The parameters in the parameter
definition file are not valid.
The code conversion specified in the
parameter definition file is not valid.
Table 66 on page 154 are generated only when using
Recommended Actions
If you specified the parameter definition file
using the [param] option, make sure that the
specified file exists and the name is correct.
If you did not specify the [param] option when
you started the FCU, make sure that the default
parameter definition file exists
(fcudata.param in the current directory).
Display the system error code using the Help-
Error command. See the OS user manual for
information on system errors.
Display the system error code using the Help-
Error command. See the OS user manual for
information on system errors.
Make sure that the FCU initiation parameters
are entered correctly in the parameter definition
file.
Make sure that the code conversion is specified
as either EA or No.
Table
Table