HP StorageWorks P9000 Manual page 84

Table 31 Error codes (part code 3005) (continued)
Part Error
Code Number
3005 58575
3005 58576
3005 58623
3005 58626
3005 58706
3005 65650
3005 65659
3005 65671
3005 65675
3005 65676
3005 65688
3005 65689
3005 65690
3005 65691
3005 65692
3005 65693
3005 65694
84 Message (part code group 3nnn)
Error Message
An error occurred while connecting to
the subsystem.
A communication time-out error
occurred in the disk subsystem.
The specified operation cannot be
performed, because the Snapshot pair
using the pool volumes to be
maintained is in PSUS status or being
restored.
A Snapshot pair is defined.
An error occurred during SVP
processing.
The specified volume is used as a
System Disk volume.
The specified volume is used as a Thin
Provisioning volume.
The pool volumes associated with the
Thin Provisioning volume is included in
the items to be maintained.
The LDEV to be operated is not included
in the specified parity group.
The association cannot be made
because the pool is in a different CLPR.
A failure occurred while formatting.
A failure occurred while quick
formatting.
The specified volumes contain volumes
that are being quick formatted.
Preparing for quick format.
The specified volumes contain volumes
that quick format cannot be executed.
Quick Format cannot be executed.
There is no System Disk area for Quick
Format, the capacity of the System Disk
is insufficient, or the System Disk is
blocked.
Quick format cannot be executed
because the number of parity groups
being quick formatted has exceeded
the maximum.
Recommended Action
If this problem persists, please contact
HP Technical Support.
If this problem persists, please contact
HP Technical Support.
Resynchronize the pair or release the
pair definition, then retry the operation.
Cancel the pair definition, then retry the
operation.
If this problem persists, please contact
HP Technical Support.
Check the setting of the specified volume.
Check the setting of the specified volume.
Release the association between the pool
volume and the Thin Provisioning volume.
Check the setting and status of the LDEV
in the specified parity group.
Confirm that it is associated with a pool
in the same CLPR.
Cancel the format processing from the
SVP, then retry the formatting processing
again.
Cancel the quick formatting processing
from the SVP, then execute the quick
formatting processing again.
Check the settings and retry the
operation.
Check the status and wait until the status
changes to a status that maintenance is
possible.
Select only the volumes that quick format
can be executed and execute quick
format.
Add the System Disk, or restore the
blocked System Disk then retry Quick
Format.
If this problem persists even though the
system disk is normal and has enough
capacity, please contact HP Technical
Support.
Change the setting or execute the quick
formatting process after the quick format
processing for other parity groups has
completed.
Severity
Level
E
E
W
W
E
W
W
W
W
W
W
W
W
W
W
W
W