HP StorageWorks P9000 Manual page 51

Table 22 Error codes (part code 00622) (continued)
Part Error Error Message
Code Number
00622 105241 An external volume that can be added
was not found by the result of
VolumeDiscovery.
00622 105242 An external volume is selected, where
Volume Discovery executed ends with
an error.
00622 105243 The emulation type that cannot coexist
is set.
00622 105244 The specified external volume cannot be
set because the path configuration is
different.
00622 105245 Failed to allocate a LDEV ID.
00622 105246 Failed to allocate a SSID.
00622 105251 The external volume is not supported.
00622 105255 Only one LDEV can be set because the
attribute of the specified external volume
is Remote Command Device.
00622 105256 Only one LDEV can be set because the
specified external volume is in the data
transfer mode.
00622 105257 LDEV Name cannot be set because the
value is out of range.
00622 105258 The path cannot be changed because
there will be no normal path for the
external volume.
00622 105262 LDEV Name can not be registered
because there is a volume that failed to
be created as an external volume.
00622 105265 Insufficient logical volumes to map the
external volumes.
00622 105266 Insufficient logical volumes to map the
external volumes.
00622 105267 You do not have a permission to treat
the ports where the specified WWNs
are derived from.
00622 105268 You do not have a permission to treat
the ports where the paths composing the
specified external path groups are
derived from.
00622 105269 You do not have a permission to treat
the specified external volumes.
00622 105270 You do not have a permission to treat
the LDEVs that are included in the
specified external volumes.
Recommended Action
See the manual of the external device
and check the setting of the external
volume.
Resolve the cause of the error, or only
select an available external volume.
Check the setting(s).
Check the contents of the path
configuration.
Check the setting(s).
Check the setting(s).
Resolve the cause of the error, or only
select an available external volume.
Check the setting(s).
Check the setting(s).
Check the setting(s).
Select one or more normal path, or
restore the path.
Edit LDEVs, or recreate external volumes
if you want to register the LDEV Name.
Reduce the number of external volumes
to be mapped, then retry the operation.
Or, check the initial-number of LDEV ID
or the interval setting.
Reduce the number of external volumes
to be mapped, then retry the operation.
Verify the available ports.
Verify the available ports.
Verify the available parity groups.
Verify the available LDEVs.
Severity
Level
W
W
W
W
W
W
W
W
W
W
W
W
W
W
W
W
W
W
Part code 00622 51