HP StorageWorks P9000 Manual page 261

Table 62 Error codes (part code 7105) (continued)
Part Error Error Message
Code Number
7105 8657 The Swap&Freeze option cannot be
specified, because the mode 80 is on.
7105 8696 The command has been rejected,
because the specified S-VOL is being
used as the T-VOL of a Compatible
FlashCopy pair.
7105 8697 The command has been rejected,
because the specified T-VOL is being
used as the volume of a Compatible
FlashCopy pair.
7105 8698 The command has been rejected,
because the specified volume is being
used as the volume of a Compatible
FlashCopy pair.
7105 8699 The Reverse Copy or Quick Restore
command has been rejected, because
the specified S-VOL is also being used
as the volume of a Compatible
FlashCopy pair.
7105 8941 The command was rejected because the
specified CT Group is already used.
7105 8942 The CT Group operation is not available
because the target DKC microcode
version does not support the CT Group
operation.
7105 8946 A pair status cannot be changed
because the Split time of Consistency
Group is set.
7105 8991 The command has been rejected,
because the Compatible FlashCopy
relationship exists.
7105 8992 The command has been rejected,
because sufficient amount of shared
memory is not installed.
7105 8993 The command has been rejected,
because the shared memory is not set
for Compatible FlashCopy.
7105 8994 The command has been rejected,
because the disk subsystem is busy.
7105 8995 The command has been rejected,
because the Compatible FlashCopy
relationship exists.
7105 8996 The command has been rejected,
because the disk subsystem is busy.
7105 55645 Quick Restore cannot be executed
because the specified pair is composed
of the external volumes with different
cache mode settings.
7105 56301 An error occurred during SVP
processing. If this problem persists,
please contact HP Technical Support.
Recommended Action
Please contact HP Technical Support.
Release the relationship to delete the
Compatible FlashCopy pair, or specify
another volume.
Release the relationship to delete the
Compatible FlashCopy pair, or specify
another volume.
Release the relationship to delete the
Compatible FlashCopy pair, or specify
another volume.
Release the relationship to delete the
Compatible FlashCopy pair.
Correct the specified CT Group and retry
the operation again.
Install the appropriate version of DKC
microcode.
Reset the Split time of Consistency Group
from the mainframe host.
Withdraw the Compatible FlashCopy
relationship.
Install additional shared memory.
Set the shared memory extension setting
for Compatible FlashCopy.
Wait a while, and retry the operation.
Withdraw the Compatible FlashCopy
relationship.
Wait a while, and retry the operation.
Use the Reverse Resync option.
If this problem persists, please contact
HP Technical Support.
Severity
Level
W
W
W
W
W
W
W
W
W
E
E
W
W
W
W
E
Part code 7105 261