HP StorageWorks P9000 Manual page 226

Table 56 Error codes (part code 6610) (continued)
Part Error
Code Number
6610 56522
6610 56523
6610 59004
6610 59005
6610 59006
6610 59007
6610 59008
6610 59009
6610 59010
6610 5901 1
6610 59013
6610 59026
6610 59030
6610 59031
6610 59040
226 Message (part code group 6nnn)
Error Message
There are no consistency groups
available. Please create unused
consistency groups and then retry the
operation.
No more mirrors can be created for the
specified volume.
An error occurred. Please check the error
details.
An invalid value is specified.
No more journal volumes can be
registered, or too many volumes are
selected.
Are you sure you want to delete the
specified subsystems?
Are you sure you want to delete the
paths of the specified subsystem?
Since the number of Preview data
exceeded the maximum, the excess data
were discarded. No more Preview data
can be stored.
WARNING:
Initial copy mode "None" is selected for
some volume pair. Are you sure that the
primary data volume and the secondary
data volume of the pair are already
synchronized?
Are you sure you want to output the %s
file?
The specified file already exists. Do you
want to overwrite this file?
The same DKC is specified more than
once. Check the DKC setting.
The monitoring data saved at present
will be deleted.
The monitoring data saved at present
will be deleted when the monitoring
switch is set to Enable the next time.
You cannot add journal volumes because
Continuous Access Journal Z is not
installed.
Recommended Action
There are no consistency groups
available. Create unused consistency
groups, then retry the operation.
Check the mirrors of the specified
volume.
Check the error information.
Specify the valid value.
Check the number of journal volumes in
the specified journal group, or check the
number of the selected volumes.
To delete the specified storage system,
click [OK]. Otherwise, click [Cancel].
To delete the specified path, click [OK].
Otherwise, click [Cancel].
Click [OK]. Apply the Preview data to
the disk storage system, then retry the
operation.
Check the contents of the primary and
secondary volumes. If the contents match,
click [Yes]. Otherwise, click [No].
To output the file, click [Yes]. Otherwise,
click [No].
To overwrite the file, click [Yes].
Otherwise, click [No].
Check the DKC setting.
To continue the operation, click [OK]. To
cancel the operation, click [Cancel].
The current monitoring data will be
deleted if you change the setting of the
monitoring switch. If necessary, use the
Performance Monitor Export Tool to
export the monitoring data file.
To continue processing, click [OK]. To
stop processing, click [Cancel].
The monitoring data currently saved will
be deleted when you change the setting
of the monitoring switch. If necessary,
use the Export Tool to save the
monitoring data.
Purchase a license for Continuous Access
Journal Z, then install it.
Severity
Level
W
W
W
W
W
W
W
i
i
i
W
W
W
i
W