HP StorageWorks P9000 Manual page 224

Table 56 Error codes (part code 6610) (continued)
Part Error
Code Number
6610 91 13
6610 91 15
6610 91 16
6610 91 17
6610 91 18
6610 91 19
6610 9120
6610 9121
6610 9122
6610 9127
6610 9128
6610 9155
6610 9303
6610 9305
6610 9306
6610 9308
6610 9309
6610 9327
224 Message (part code group 6nnn)
Error Message
Are you sure you want to clear SIMs of
Continuous Access Journal and
Continuous Access Journal Z?
The monitoring was stopped by another
operator. The graph will be closed.
Another operator has changed the
Gathering Interval value. The graph will
be closed.
Are you sure you want to close the
graph?
Please check the specified value.
No graph item has been selected. Please
select a graph item.
The graph will be closed if you execute
the processing. Do you want to execute
the processing?
Data has been changed and the graph
has been displayed. If you continue this
operation, all the data and the graph
will become invalid. Are you sure you
want to continue this operation?
Are you sure you want to export pair
status?
Are you sure you want to close all active
graphs?
The specified volume was not found.
The history file has been updated. Select
the OK button to display the history logs
from the beginning.
There are no valid volumes.
There are no initiator ports.
The Continuous Access Journal Z function
is not installed in this controller. You
cannot create pairs.
You set the same path more than once.
The duplicate paths are excluded.
All paths which you set have already
been registered. This operation will
terminate because there is no path which
can be added.
The monitoring time is over, but the
history file is not fully updated yet.
Recommended Action
To clear SIMs, click [Yes]. Otherwise,
click [No].
Click [OK].
Click [OK].
To close the graph, click [OK].
Otherwise, click [Cancel].
To apply this setting, click [OK]. To
change the setting, click [Cancel].
Select a graph item.
To execute the processing and close the
graph, click [OK]. Otherwise, click
[Cancel].
To execute this operation, click [OK].
Otherwise, click [Cancel].
To export, click [OK].
To cancel the operation, click [Cancel].
To close the graphs, click [OK].
Otherwise, click [Cancel].
Click [OK], then specify the correct
volume.
Click [OK].
Click [OK], then specify the correct
volume.
Set the port to Initiator before registering
the storage system.
Obtain a license for Continuous Access
Journal Z, then install it.
Since there are duplicated paths in the
added paths, the duplicated paths will
be eliminated. Click [OK] to continue.
Since all the added paths are redundant,
the paths cannot be added. Click [OK]
and continue.
Click [Refresh] to update the history file.
If this problem persists, please contact
HP Technical Support.
Severity
Level
W
i
i
W
i
W
W
W
i
W
W
i
W
W
W
W
W
i