Part Code 6610 - HP StorageWorks P9000 Manual

Table 55 Error codes (part code 6510) (continued)
Part Error
Code Number
6510 65780
6510 69016
6510 69017
6510 69018
6510 69019
6510 69021
6510 69084

Part code 6610

Table 56 Error codes (part code 6610)
Part Error
Code Number
6610 5030
6610 5137
6610 5138
6610 5140
6610 5141
6610 5144
6610 7301
6610 7302
6610 7303
6610 7440
222 Message (part code group 6nnn)
Error Message
The same mirror ID is specified in the
mirror 1 and the mirror 2 parameters.
Are you sure you want to cancel the
export?
No more journals can be registered,
because the number of registered
journals has reached the maximum.
There are two or more LDKC numbers
for the specified data volume. In this
operation, please specify only one LDKC
number.
The number of data volumes exceeds the
maximum.
Journals cannot be added to the
extended consistency group (EXCTG),
because the number of EXCTG exceeds
the maximum.
Do you want to release the remote
command device from the mirror?
Error Message
The displayed information has not been
changed.
The Operation value is invalid. Specify
the correct value.
The value specified for Gathering Interval
is invalid. Specify a valid value within
the range of 1 to 15.
The specified CU number is incorrect.
Specify the correct CU number.
The specified LDEV number is incorrect.
Specify the correct LDEV number.
Some of the entered values are incorrect.
Check the values and then specify
correct values.
An error occurred in client logic.
An error occurred in client logic.
An error occurred in client logic.
An error occurred during processing. If
this problem persists, please contact HP
Technical Support.
Recommended Action
Specify different mirror IDs in the mirror
1 and the mirror 2 parameters.
To stop the operation, click [OK].
To continue the operation, click [Cancel].
Check the number of registered journals.
Check the LDKC number for the specified
data volume, and specify only one LDKC
number.
Check whether the specified volume is
a LUSE volume. Also, check storage
system's microcode version.
Check the number of registered EXCTG.
To continue the operation, click [OK].
Otherwise, click [Cancel].
Recommended Action
Specify the data that you want to register
in the SVP, and retry the operation.
Check the contents, and retry.
Check the contents, and retry.
Specify the correct CU number.
Specify the correct device number.
Check the values, then specify correct
values.
Please contact HP Technical Support.
Please contact HP Technical Support.
Please contact HP Technical Support.
If the same error occurs despite retrying,
please contact HP Technical Support.
Severity
Level
W
i
W
W
W
W
W
Severity
Level
W
W
W
W
W
W
E
E
E
E