HP StorageWorks P9000 Manual page 173

Table 52 Error codes (part code 6010) (continued)
Part Error Error Message
Code Number
6010 9324 The specified operation is prohibited
while the script is running.
6010 9325 The script is terminated forcibly.
6010 9327 The monitoring time is over, but the
history file is not fully updated yet.
6010 9332 This operation is not applied yet.
6010 9337 The requested operation has started.
6010 9360 The specified value exceeds the range.
Alternatively, the relationship between
the specified values is not appropriate.
6010 55035 If you plan to create a pair with the
specified LUSE volumes, a DKC path is
required.
6010 55202 The subsystem specified by Controller ID
is not available for the particular CU
selected from the tree.
6010 55203 There are no initiator ports that can be
used by the subsystem specified by
Controller ID.
6010 55204 The M-VOL or R-VOL is not supported by
the specified RCU.
6010 56537 There are no consistency groups
available for the CLPR of the specified
volumes. Please register the consistency
groups and then retry the operation.
6010 56540 The size of the specified file exceeds 8
megabytes, so the file cannot be
uploaded.
6010 59001 Are you sure you want to cancel the
change operation of the option
parameter that you specified?
6010 5901 1 Are you sure you want to output the %s
file?
6010 59012 The %s file does not exist.
6010 59013 The specified file already exists. Do you
want to overwrite this file?
6010 59026 The specified RCU has been already set.
Check the RCU parameter settings.
6010 59030 The monitoring data saved at present
will be deleted.
Recommended Action
Try again after the script ends.
Click [OK].
Click [Refresh] to update the history file.
If this problem persists, please contact
HP Technical Support.
Click [OK], then continue the operation.
The requested operation has started.
Click [OK] to close the dialog.
Check the specified values and retry the
operation.
Select "Add RCU" command, then
register a DKC path.
Find the CUs that can be used by the
storage system specified by the
Controller ID.
Find the ports that can be used by the
storage system specified by the
Controller ID, and set them as initiator
ports.
Check the settings of the specified RCU,
M-VOL and R-VOL.
Register the consistency groups, then
retry the operation.
Check the size of the file, decrease the
size and retry the operation.
To cancel the change operation of the
option parameter, click [OK]. Otherwise,
click [Cancel].
To output the file, click [Yes]. Otherwise,
click [No].
Click [OK].
To overwrite the file, click [Yes].
Otherwise, click [No].
Check the RCU parameter settings.
To continue the operation, click [OK]. To
cancel the operation, click [Cancel].
The monitoring data currently saved will
be deleted if you change the setting of
the monitoring switch. If necessary, use
the Performance Monitor Export Tool to
export the monitoring data file.
Severity
Level
W
i
i
i
i
W
W
W
W
W
W
W
W
i
i
W
W
W
Part code 6010 173