HP StorageWorks P9000 Manual page 172

Table 52 Error codes (part code 6010) (continued)
Part Error
Code Number
6010 9300
6010 9301
6010 9303
6010 9305
6010 9306
6010 9307
6010 9308
6010 9309
6010 9310
6010 931 1
6010 9316
6010 9317
6010 9318
172 Message (part code group 6nnn)
Error Message
WARNING: Destination volume of
specified volume pair may contain some
inconsistency, because volume copy is
not completed yet. Full volume
initialization is required before re-using
it.
WARNING: Through this operation,
M-VOL status will be changed to SMPL
status forcibly, but R-VOL status will not
be changed. If you do this operation,
please change the R-VOL status to SMPL
later.
There are no valid volumes.
There are no initiator ports.
The Remote Copy function is not installed
in this controller. You cannot create
pairs.
You specified the same volumes more
than once. The duplicate occurrences
were excluded.
You set the same path more than once.
The duplicate paths are excluded.
All paths which you set have already
been registered. This operation will
terminate because there is no path which
can be added.
You set the same SSID more than once.
Duplicate SSIDs are excluded.
All SSIDs which you set have already
been registered. This operation will
terminate because there is no SSID which
can be added.
Through this operation, M-VOL status will
be changed to Simplex mode even if the
M-VOL is online to the host.
The destination volume of the specified
volume pair may contain some
inconsistency because volume copy is
not completed yet. Full volume
initialization is required before re-using
it.
As a result of this operation, you will not
be able to re-start ERASE R-VOL
operation.
Recommended Action
Follow the instructions in the message.
Follow the instructions in the message.
Confirm whether the command device
for Business Continuity Manager is
defined.
Set the port to Initiator before registering
RCU.
There is no Remote Copy license. Set the
license.
Since the same volume where multiple
paths are defined was selected, the
overlapped one was eliminated. Click
[OK] and continue.
Since there were overlapped paths in
the added paths, the overlapped paths
were eliminated. Click [OK] and
continue.
Since all the added paths overlapped,
the operation of adding paths cannot be
executed. Click [OK] and continue.
Since there were overlapped SSIDs in
the added SSIDs, the overlapped SSIDs
were eliminated. Click [OK], and
continue.
Since all the added SSIDs are
overlapped, the operation of adding
SSIDs cannot be executed. Click [OK],
and continue.
Follow the instructions in the message.
Follow the instructions in the message.
To delete the pair, even though you
cannot re-execute the R-VOL deletion,
click [OK]. If not, click [Cancel].
Severity
Level
i
i
W
W
W
W
W
W
W
W
W
i
i