HP StorageWorks P9000 Manual page 169

Table 52 Error codes (part code 6010) (continued)
Part Error Error Message
Code Number
6010 5138 The value specified for Gathering Interval
is invalid. Specify a valid value within
the range of 1 to 15.
6010 5139 The Script File Name value is invalid.
Specify the correct value.
6010 5140 The specified CU number is incorrect.
Specify the correct CU number.
6010 5141 The specified LDEV number is incorrect.
Specify the correct LDEV number.
6010 5142 The specified GID is incorrect. Specify
the correct GID.
6010 5143 The specified LUN is incorrect. Specify
the correct LUN.
6010 5144 Some of the entered values are incorrect.
Check the values and then specify
correct values.
6010 7060 An error occurred in the client logic.
6010 7301 An error occurred in the client logic.
6010 7302 An error occurred in the client logic.
6010 7303 An error occurred in the client logic.
6010 7440 An error occurred during processing. If
this problem persists, please contact HP
Technical Support.
6010 8101 The system cannot apply the new
configuration. Do you want to refresh?
6010 8928 An error occurred when copying started.
Do you want to recover from the error
condition?
6010 9006 Exchange the channel cable connections
after confirmation of the port type.
6010 9007 Please confirm that the R-VOLs to specify
are varied off-line.
6010 9008 SIMs of Remote Copy are cleared.
6010 9009 The export is complete.
6010 9021 The Port Setting process has not
completed. Do you want to continue for
other ports?
6010 9022 WARNING: Initial copy mode 'None'
is selected for some volume pairs. Are
you sure that the M-VOL and the R-VOL
of these pairs are already synchronized?
Recommended Action
Check the contents, and retry.
Check the contents, and retry.
Specify the correct CU number.
Specify the correct device number.
Specify the correct group number.
Specify the correct LUN.
Check the entered values, then specify
correct values.
Please contact HP Technical Support.
Please contact HP Technical Support.
Please contact HP Technical Support.
Please contact HP Technical Support.
If this problem persists, please contact
HP Technical Support.
Click [Refresh], and retry.
Click [Yes] to recover from the error
condition. If not, click [No].
If the recovery fails despite retrying,
suspend the corresponding pair
temporarily, and execute Resume Pair
(Pairresync) operation.
Follow the instructions in the message.
Confirm that the R-VOLs to specify are
varied off-line.
Click [OK].
Click [OK].
Click [Yes] to continue processing. After
processing is complete, reset the port
that is not in operation.
Check the contents of the main and
remote volumes. If the contents match,
click [OK]. If not, click [Cancel].
Severity
Level
W
W
W
W
W
W
W
E
E
E
E
E
W
W
i
i
i
i
i
i
Part code 6010 169