HP StorageWorks P9000 Manual page 164

Remote web console messages
Hide thumbs Also See for StorageWorks P9000:
Table of Contents

Advertisement

Table 50 Error codes (part code 6005) (continued)
Part
Error
Code
Number
6005
68792
6005
68793
6005
68794
6005
68795
6005
68796
6005
68812
6005
68813
6005
68816
6005
68817
6005
68826
164 Message (part code group 6nnn)
Error Message
The operation failed because the
specified volume was not an External
Storage Access Manager pair volume.
The Reverse Resync operation failed
because the status of the specified
volume was not SSWS.
The operation failed because the path
from the RCU to the MCU did not exist.
The operation failed. The shared
memory might be insufficient.
Please contact HP Technical Support.
The operation failed. The operation
cannot be accepted in the pair status
of the specified volume.
A pair could not be created because
the specified R-VOL was a Thin
Provisioning volume whose capacity
was being changed.
A pair could not be created because
the specified M-VOL was a Thin
Provisioning volume whose capacity
was being changed.
A pair cannot be created because the
specified volume is used as a primary
data volume of the Continuous Access
Journal.
The specified R-VOL was a pair volume
of the Continuous Access Journal.
A pair could not be created because
"Cylinder" was set to the "Difference
Management."
The operation failed, because the
External Storage function was not
installed.
Recommended Action
Refresh the window, and
confirm whether the
specified volume is an
External Storage Access
Manager pair volume.
Refresh the window, and
confirm whether the status of
the specified volume is
SSWS.
Create a path from the RCU
to the MCU.
Contact the Support Center,
and check the shared
memory.
Refresh the window, and
confirm the pair status of the
specified volume.
Check each capacity of the
M-VOL and the R-VOL after
the capacity change of
R-VOL ends, and plan a
combination of volumes for
pair creating.
Check each capacity of the
M-VOL and the R-VOL after
the capacity change of
M-VOL ends, and plan a
combination of volumes for
pair creating.
The specified volume is a
primary data volume of the
Continuous Access Journal,
which runs on the 2DC
configuration in which the
Continuous Access
Synchronous or External
Storage Access Manager
cooperates. Specify another
volume.
The RCU runs on the 2DC
configuration in which the
Continuous Access Journal
cooperates.
Set "Track" to the
"Difference Management,"
then retry the operation.
Install the External Storage,
then retry the operation.
Severity Level
W
W
W
E
W
W
W
W
W
W

Advertisement

Table of Contents
loading

This manual is also suitable for:

Xp p9500Storageworks p9500

Table of Contents