Returned Values; Error Codes - HP StorageWorks P9000 Reference Manual

Option
-E
-fq <mode>

Returned values

The pairsplit command sets the following returned values during exit, allowing you to check the
execution results:
Normal termination: 0. When splitting groups, 0 = normal termination for all pairs.
Abnormal termination: Other than 0, see the execution logs for error details.

Error codes

The following table describes the error codes for the pairsplit command. Unrecoverable errors are
fixed and not resolved, even after re-executing the command. If the command failed, the detailed
status is logged in the RAID Manager command log ($HORCC_LOG), even if the user script has
no error handling.
Description
Business Copy only.
Suspends a paired volume forcibly when a failure occurs. Not normally used.
-FHORC [MU#] or -FCA [MU#]: Forcibly specifies a cascading Continuous Access Synchronous
volume for specified volume pair on Business Copy environment. If the -l option is specified, a
cascading Continuous Access Synchronous volume is split on a local host (near site). If the -l option
is not specified, a cascading Continuous Access Synchronous volume is split on a remote host (far
site). The target HORC volume must be a P-VOL, or "-R[S][B]" option can be specified on S-VOL.
-FMRCF [MU#] or -FBC [MU#]: Forcibly specifies a cascading Business Copy volume for specified
volume pair on Continuous Access Synchronous environment. If the -l option is specified, a cascading
Business Copy volume is split on a local host (near site). If -l option is not specified, a cascading
Business Copy volume is split on a remote host (far site). The target Business Copy volume must be
a P-VOL, and the -E option cannot be specified.
Business Copy only.
This option is used to specify the mode whether "pairsplit" is performed or not as "QUICK".
mode = normal"pairsplit" is performed as Non quick mode regardless of setting of $HORCC_SPLT
environment variable and/or the system option mode 122 via SVP.
mode = quick"pairsplit" is performed as Quick Split regardless of setting of $HORCC_SPLT
environment variable and/or the system option mode 122 via SVP.
If this option is not specified, then performing the "Split" depends on $HORCC_SPLT environment
variable and/or the system option mode setting through the SVP whether the operation of BC is
executed by Quick -Split or not.
The relationship between "-fq" option and $HORCC_SPLT is as shown below.
-fq option $HORCC_SPLT Behavior
------------------------------------------------
quick Don't care Quick Split
normal Don't care Normal Split
Unspecified QUICK Quick Split
Unspecified NORMAL Normal Split
Unspecified Unspecified Depends on system option mode 122
NOTE:
The -fq option is also validated on Cnt Ac-S-Cnt Ac-S/Business Copy cascading operation using
"-F BC [MU#]" option.
The -fq option is applied for only P9500, XP24000/XP20000, and XP12000/XP10000 Disk
Arrays. This option is ignored for XP1024/XP128 Disk Array, in order to maintain compatibility
on XP1024/XP128 Disk Array, so that you can use the same script adding this option.
pairsplit 31