Page of 3

HP P2000 Installation Instructions

Hp storageworks controller module installation instructions (590339-004, june 2010).
Hide thumbs
   
HP StorageWorks
Instructions
This document details procedures for installing a con-
troller module in HP StorageWorks array enclosures.
© Copyright 2009, 2010 Hewlett-Packard Development Company,
L.P.
Second edition: March 2010
The information in this document is subject to change without notice.
Printed in the US.
www.hp.com
*590339-004*
Illustrations in this document show generic representations of modules
and enclosures; procedures are the same for all modules shipped
with this document.
The Storage Management Utility (SMU) and the Command Line Inter-
face (CLI) can be used to manage the enclosure. Tasks in this docu-
ment demonstrate using the SMU.
For the latest product documentation, see the HP website at
www.hp.com/support/manuals. Under the storage banner, navigate
to the page for your storage enclosure.
Observe the following:
CAUTION:
Removing a module from an operational enclosure significantly
changes air flow within the enclosure. Openings must be
populated for the enclosure to cool properly. Leave modules
in the enclosure until a replacement is available.
Parts can be damaged by electrostatic discharge; use proper
anti-static protection. Keep parts in electrostatic containers
until needed and ensure you are properly grounded when
touching static-sensitive components.
IMPORTANT:
When two controllers are installed in an enclosure, they must
be the same model. Mixing controller types in the same
enclosure is not supported.
NOTE:
To reduce impact on system performance, perform all
maintenance tasks during periods of low system activity or
during a system maintenance window.
The following illustration shows controller module locations:
1. Controller A
Page 1
http://
2. Controller B

Advertising

   Also See for HP P2000

   Related Manuals for HP P2000

   Summary of Contents for HP P2000

  • Page 1: About This Document, Controller Module Installation, Before You Begin

    IMPORTANT: © Copyright 2009, 2010 Hewlett-Packard Development Company, When two controllers are installed in an enclosure, they must L.P. be the same model. Mixing controller types in the same enclosure is not supported.

  • Page 2

    Enabling Partner Firmware Update Installing the new module (dual-controller configurations only) IMPORTANT: In a dual-controller configuration, the Partner Firmware Update option When installing modules in a new system, install the first module ensures that both controllers have the most recent version. HP in the top bay.

  • Page 3: Verifying Proper Operation, Additional Information

    As appropriate for your environment, connect cables from this new module to the host or other disk enclosures. For more information about cabling and configuring the system, see the user guide. Additional information HP P2000/MSA Disk Arrays: http://www.hp.com/go/msa HP storage: http://www.hp.com/storage HP support: http://www.hp.com/support...

Comments to this Manuals

Symbols: 0
Latest comments: