Car Car E And Cleaning E And Cleaning E And Cleaning; Filters; Lights - Electrolux RH30WC55GS Installation, Use & Care Manual

18 18 18 18
Care and cleaning
The frequency of cleaning depends on the amount
and type of cooking.
Do not use the ventilating system without the
surfaces.
Always unplug or disconnect the appliance from the
power supply before servicing.
attempting to clean any part of the appliance.

Filters

Filters Filters Filters Filters
anodized aluminum and are long lasting.
T T T o Remove The Metal Gr o Remove The Metal Gr o Remove The Metal Grease Filters o Remove The Metal Gr
o Remove The Metal Gr
Pull the spring release handle.
T T T o Replace The Metal Gr o Replace The Metal Gr o Replace The Metal Grease Filters o Replace The Metal Gr o Replace The Metal Gr
Reverse procedure.
T T T o Clean Filters o Clean Filters o Clean Filters
o Clean Filters o Clean Filters
least once a month; they can be washed by hand
or in the dishwasher.
dry thoroughly before replacing it.
ease Filters ease Filters ease Filters
ease Filters
ease Filters ease Filters ease Filters ease Filters
Care and cleaning

Lights

Before replacing the lamps, switch power off at
service panel and lock service panel disconnecting
means to prevent power from being switched on
accidentally.
NOTE: Turn off the lights and fan. Allow the
lights to cool before handling. Replace lights
per instructions. If new lights do not operate,
be sure lights are inserted correctly before
calling service.
Replace Lights
•
Remove the inner lamp lens cover by inserting a
slots and gently prying it free.
NOTE: Do not remove the outer trim ring (lamp
assembly).
Inner
ring
The glass lens and inner trim ring are 2 pieces
loose tting. Be careful when removing the trim
ring that the glass lens does not fall out.
•
Grasp the bulb and pull it straight out from the
lamp socket.
• Replace with 120 volt, 40 watt halogen bulbs with
a G9 base SUITABLE FOR USE IN OPEN
LUMINAIRES.
Follow package directions, wear gloves, do not
touch bulb with your bare ngers.
Bulb
NOTE: Once you have replaced the light bulb,
make sure to put back the glass in its place.
Outer
ring
• Replace inner cover by
inserting the three
retaining tabs into the
three slots and pressing
them rmly in place.