Using the Setup menu
Configure setting such as audio quality for tracks that are played back on the device, the playback method, power, and display.
1 With the power turned on, press MENU.
Menu screen appears on the front panel display.
2 Use a/b to select 'Setup', then press ENTER.
Setup screen appears on the front panel display.
3 Select the setting you want to adjust.
! Use abcd and ENTER on the remote control to navigate through the screens and select menu items.
to confirm and exit the current menu.
4 Press MENU to exit the Setup menu.
Configure the Playback settings
To configure the playback settings, select Playback in the Setup menu.
! These settings apply to all playback functions and songs of the device. (Beatless Skip, Eight Skip and Auto Level Adjust cannot be used for songs
that have not been analyzed).
See the table below for the options available for each setting. The defaults, if not stated, are listed in bold.
Beatless Skip *1
8 Skip *1
Dance Sound *2
Sound Retriever *3
Auto Level Adjust *1
Effective only for songs that have been analyzed.
You cannot change the settings when the headphone is connected or when a rhythm is being played back.
The Loudness cannot be changed when the Dance Sound is on. When the Loudness is on, the Dance Sound cannot be changed.
You cannot change the settings when a rhythm is being played back.
What it does
Plays back songs in ways that are easy for dancing by eliminating spoken parts and sections where
there are no beats.
The unit for Eight Skip is 1-eighth (eight beats).
Adds effects to songs and emphasizes beats to play them back in a sound that is easy for dancing.
You can select the level of effects in STZ-D10T.
You can turn on or off the effects in STZ-D10S.
Used to get good bass and treble from music sources at low volumes.
Will recover the portion that is deleted when music file is compressed to improve sound closeness and
Evens out the volume differences among songs and plays them back at a volume that is easy for
You can set the maximum volume to prevent loudness when connecting a headphone.
Sound Retriever Off
0 to 50
Default: 50 (unrestricted)