Optional Paper Tray (Lt-5400); Memory Board; So-Dimm Types - Brother MFC-8910DW Advanced User's Manual

Optional paper tray
(LT-5400)
An optional lower tray can be installed on
MFC-8710DW, MFC-8810DW and
MFC-8910DW, and it can hold up to 500
sheets of 20 lb / 80 g/m
When an optional tray is installed, the
machine can hold up to 800 sheets of plain
paper.
For setup, see the Instructions that we have
supplied with the lower tray unit.
WARNING
If you use a Lower Tray, DO NOT carry the
machine with the Lower Tray as you may
be injured or cause damage to the machine
because it is not attached to the Lower
Tray.
B
2
paper.

Memory board

MFC-8810DW and MFC-8910DW have
128 MB of standard memory, and
MFC-8510DN and MFC-8710DW have
64 MB. All models have one slot for optional
memory expansion. You can increase the
memory up to maximum of 384 MB for
MFC-8810DW and MFC-8910DW and 320
MB for MFC-8510DN and MFC-8710DW by
installing one SO-DIMM (Small Outline Dual
In-line Memory Module).

SO-DIMM Types

For information regarding memory for your
Brother machine please visit us at:
http://www.brother-usa.com/support/
memory/.
In general, the SO-DIMM must have the
following specifications:
Type 144-pin and 16-bit output
CAS latency 4
Clock 267 MHz (533 Mb/S/Pin) or
frequency more
Capacity 256 MB
Height 1.18 in. (30.0 mm)
DRAM type DDR2 SDRAM
Note
• There might be some SO-DIMMs that will
not work with the machine.
• For more information, call the dealer you
bought the machine from or Brother
Customer Service.
Options
B
B
B
75