Sony KDL-46HX820 Installation Manual page 3

CAUTION
The wall that the TV will be installed on should be capable of supporting a weight of at least four times that of the
TV. Refer to your TV's operating instructions for its weight.
2 Install the Wire Bracket on the wall.
Refer to the Instructions for SU-WH500.
3
Disconnect all the cables from the TV.
4 Detach the Table-Top Stand from the TV.
Remove the screws indicated by the arrow marks
Table-Top Stand attached to TV.
Soft cloth
✍
• Do not remove the Table-Top Stand for any reason other than to install corresponding accessories on
the TV.
• When removing the Table-Top Stand from the TV, lay the TV face down on a stable work surface that is
larger than the TV.
• To prevent damaging the surface of the TV, make sure to place a soft cloth on the work surface.
• When lifting or moving the TV, keep a soft cloth underneath to prevent damage.
• The number and position of the screws on the rear of the TV differs, depending on the model of TV; be
sure to read the operating instructions of your TV.
• Be sure to remove the joint when the Table-Top Stand is not attached to the TV.
• Be sure the TV is in a vertical position before turning it on. The TV set must not be powered on with
the LCD panel face down to avoid uneven picture uniformity.
CAUTION
• If pressure or shock is applied to the surface of the TV, the TV may break or become damaged.
• Lay the TV face down on a stable and level surface with the Table-Top Stand hanging over the edge of
the surface. Having the TV face and the base of the Table-Top Stand on the same level surface will create
an unstable working condition and can damage the TV.
• When detaching the Table-Top Stand from the TV, hold the Table-Top Stand securely with both hands.
Additional Information for Using Sony Wall-Hanging Bracket (SU-WH500)
on the TV.
Table-Top Stand not attached to TV.
Soft cloth
−  −