Map Output Bins Menu Options; Descriptions Of Output Bin Values - Lexmark T656 User Manual

3.6 MAP OUTPUT BINS Menu Options

This option defines the mapping of the host's request for a physical output bin in the printer. The printer
physical bin is mapped to an IPDS output bin selection number that is specified in the IPDS data stream.
Printer output bins include the top of the printer (standard bin) and optional output bins that attach to the
printer.
Some printer models may not support all bins listed. The optional printer output bin value will only be
displayed when the physical output bin is installed on the printer. Bin x Hp values and Fin High Cap Hp
values are only displayed when an optional finisher that supports hole punching is installed. Pages can be
hole punched using the "Hp" value settings. See Hole Punching on page 61 for additional information.
You can configure up to 12 mappings. This allows the Standard Bin, up to 10 optional bins, and a special
high capacity setting (Fin High Cap) explained in section 3.6.1 on page 37.
Select a Bin Mapping x in the MAP OUTPUT BINS menu group (the value x represents any given Bin
Mapping number). This displays a list of Output Bin Values that identify the available printer physical
bins. When you select an Output Bin Value, the operator panel displays a numerical setting screen to set
the IPDS bin selection number that will select that physical bin.
Bin Mapping 1 through
Bin Mapping 12
Output Bin Value
IPDS Bin Selection
Number Values

3.6.1 Descriptions of Output Bin Values

Output bin values are associated with physical bins on the printer. Bin values will only appear in the
menu when the physical bin is available on the printer.
A description for each output bin value is given below.
Std Bin – Selects the printer standard output bin.
Bin Mapping x is a sub-menu selection item.
Each item refers to the number of the mapping, not to the physical
printer output bin.
Output Bin Values specify the physical printer output bin. The output
bin values specified below are available under the specified printer's
Bin Mapping sub-menu when the physical bin is installed and
available. General Descriptions of Output Bin Values are found on
page 37.
Check your printer documentation for information on optional bin
and finisher support. Values that may be displayed when optional
bins or optional finishers are installed are shown below.
Standard Bin, Bin 1, Bin 2, Bin 3, Bin 4, Bin 5, Bin 6, Bin 7, Bin 8,
Bin 9, Bin 10, Fin High Cap, Bin 1 Hp, Bin 2 Hp, Fin High Cap Hp,
No Map
The value range for the IPDS Bin Selection Number is 1 to 255. If
an IPDS bin selection number is mapped (used) twice, the lowest bin
mapping (if available) is used. General Descriptions of IPDS Bin
Selection Numbers are found on page 38.
37