Route the diskette drive data cable between the system board and the hard drive cage. Your cable
might look different than the one shown.
be necessary to push the cable down so that it catches on the system board. This routing
method is important because it avoids interference with the CPU heatsink fans and blocking
Connect the cables to the back of the diskette drive.
Replacing a hard drive
For more information on SATA hard drives and the SATA RAID configuration, see
devices on page
Removing a hard drive
Disconnect power from the system (
Disconnect the cables from the hard drive.
Chapter 4 Removal and replacement procedures
The cable must stay between the system board and the hard drive cage. It might
Routing the diskette drive cable to the system board
(Access panel on page
Pre-disassembly procedures on page
55), and remove the