Select CD-ROM Drive , and enable it as a bootable device by pressing the
enabled, pressing the
Set the CD-ROM Drive to the top of the boot order. Select CD-ROM, press the
the up arrow to move it to the top of the boot order.
To apply and save changes, press the
Insert the Documentation & Diagnostic CD into the workstation.
Restart your system, HP Insight Diagnostics launches automatically.
Download the ISO image
Browse to http://www.hp.com.
Click Software & Driver Downloads.
Enter your product number (for example, xw8400) in the text box, and press the
Select your operating system.
Click the Diagnostic link.
Locate HP Insight Diagnostics Offline on the display, and click Download.
The Insight Diagnostics home page contains the following tabs: Survey, Test, Status, Log, and
Help. These tabs separate the major functions of Insight Diagnostics.
When you click the Survey tab, the Survey menu displays and enables you to view important system
configuration information. The Summary view limits the amount of data displayed, while the
Advanced view shows all the data in the selected category. Regardless of whether you choose
Advanced or Summary, the following categories of information are available on the Survey menu:
Overview—Lists general information about the computer.
All—Lists all information about the computer.
Architecture—Shows the type of bus the computer uses, and BIOS information. In addition, if the bus
is PCI, information about the PCI configuration is displayed.
Asset Control—Shows the serial number of the computer, and provides processor information.
Communication—Shows information about the computer parallel (LPT) and serial (COM) port settings,
USB, and network controller information.
Graphics—Shows information about the graphics subsystem of the computer.
Input Devices—Shows information about the type of keyboard and mouse.
Memory—Shows information about all memory in the computer, including memory on the board and
any memory modules installed.
Chapter 5 System diagnostics and troubleshooting
key again disables the device). The default setting is enabled.
key, and select File>Save Changes and Exit.
key (if not already
key, and use