Download Print this page
HP Workstation xw4000 Hardware Installation
HP Workstation xw4000 Hardware Installation

HP Workstation xw4000 Hardware Installation

Rack mount tray installation
Hide thumbs Also See for Workstation xw4000:

Advertisement

Rack mount tray installation
Introduction
This document describes how to install the HP
tray. It also describes how to mount the workstation-tray assembly into a rack.

Kit contents

Rail assembly
Rack glide strips
M5 and M6 hardware packets
Rack mount template card
Warranty
Rack mount installation instructions
Rack mount tray

Required tools

T-15 Torx screwdriver
T-20 Torx screwdriver
Cross-tip screwdriver
ENWW
400 and xw4000 Workstation series into a rack mount
© 2005–2009 Hewlett-Packard Development Company, L.P. Printed in the U.S.
Introduction
1

Advertisement

loading

Summary of Contents for HP Workstation xw4000

  • Page 1: Kit Contents

    Rack mount template card ● Warranty ● Rack mount installation instructions ● Rack mount tray Required tools ● T-15 Torx screwdriver ● T-20 Torx screwdriver ● Cross-tip screwdriver © 2005–2009 Hewlett-Packard Development Company, L.P. Printed in the U.S. ENWW Introduction...
  • Page 2: Warnings And Cautions

    Warnings and cautions WARNING! Any surface or area of the equipment marked with this symbol indicates the presence of an electrical shock hazard. To reduce the risk of injury from electrical shock, do not open any enclosed area marked with this symbol. WARNING! To reduce the risk of electric shock or damage to your equipment: —...
  • Page 3: Step 1-Preparing The Workstation

    Step 1—Preparing the workstation NOTE: All illustrations are examples only. Workstation models vary. For product-specific information, see the service guide for your HP workstation at http://www.hp.com/support/workstation_manuals before beginning installation. To prepare the workstation for component installation: Power down the workstation, and then disconnect the power cord. Power down all external devices, and then disconnect them from the workstation.
  • Page 4 Align the screw holes in the tray with the screw holes at the rear of the workstation Figure 3 Fastening the tray to the workstation Use a T-15 Torx screwdriver to fasten the tray to the workstation with the two chassis screws saved earlier.
  • Page 5: Step 4-Completing Installation

    To mount the workstation into the rack: Place the workstation with the attached tray onto the rails in the rack. Slide the workstation into the rack. Use a cross-tip screwdriver to secure the workstation to the rail mounting flanges with two M6 screws Figure 5 Fastening the workstation to the rack...