Microsoft Windows NT
4.0 Workstation
Connecting to a
Windows NT 4.0 Server
6 Installing the IBM Token-Ring 16/4 PCI Adapter
Microsoft Windows NT 4.0 Workstation
6 Installing the IBM Token-Ring 16/4 PCI Adapter
Requirements
• HP Vectra with Windows NT 4.0 Workstation.
• IBM Token-Ring 16/4 PCI adapter and driver disk version 2.10.
• Driver File: IBMTRP.SYS, version 2.22
• Microsoft Windows NT 4.0 Workstation media.
• Microsoft Windows NT 4.0 Service Pack 4 media.
• Microsoft Windows NT 4.0 Server system that supports NetBEUI, NWLink
IPX/SPX Compatible Transport, and NWLink NetBIOS network protocols.
Device Configuration
Device Configuration
Interrupt
I/O Address
Procedure
1 With the HP Vectra turned off, install the IBM Token Ring PCI adapter
card into a PCI slot.
2 Connect network cable media to the IBM Token Ring card.
3 Log onto Windows NT4 Workstation with administrator privileges
(Contact your network administrator if you do not have the required
information).
4 Right-click on the "Network Neighborhood" icon and select "Properties".
5 Click on "Yes" when prompted to install Windows NT Networking.
6 Select "Wired to the network" and click on "Next".
7 Click on the "Select from list..." button and then the "Have Disk..."
button.
8 Insert the IBM "PCI token Ring Adapter NDIS Drivers" disk into the floppy
drive.
Vectra Vli8
11
03
1400
D800
Vectra VEi7
Vectra VEi8
11
E400