Replacing The Cover After Installing Accessories - HP Vectra VE 6/xxx - 8 User Manual
Hp vectra ve 6/xxx series 8, user's guide for minitower models
Hide thumbs
Also See for Vectra VE 6/xxx - 8:
- Maintenance manual (104 pages) ,
- Handbook (8 pages) ,
- User manual (58 pages)
Table of Contents
Advertisement
Replacing the Cover After Installing Accessories
1 Make sure that you have installed all your accessories and that all
internal cables are properly connected and safely routed.
2 Lower the cover onto the PC chassis and slide it into position. Make
sure that the two guides at the bottom of the cover slide into the two
rails at the base of the chassis, and that the guides at the front of the
cover slide into the rails at the front of the chassis.
3 Tighten the three thumb screws at the rear of the cover.
Step 2
4 Reconnect all cables and power cords.
2 How to Install Accessories in Your PC
Removing and Replacing the Cover
Step 3
English
21
Advertisement
Table of Contents
