Fan (For Models With Uma Graphics Subsystems) - Compaq Presario CQ41-200 - Notebook PC Maintenance And Service Manual

Removal and replacement procedures

Fan (for models with UMA graphics subsystems)

Description
Fan
Before removing the fan:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the computer on,
and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first disconnecting the power cord from the AC outlet and then
disconnecting the AC adapter from the computer.
4. Remove the battery (see
5. Remove the following components:
a. Hard drive (see
b. Memory module (see
c. RTC battery (see
d. WLAN module (see
e. Optical drive (see
f. Keyboard (see
g. Keyboard cover (see
h. Speaker assembly (see
i. Display assembly (see
j. Top cover (see
k. System board (see
Remove the fan:
1. Position the base enclosure with the front toward you.
2. Remove the two black Phillips PM2.5×5.0 screws 1 that secure the fan to the computer.
3. Lift the fan from the base enclosure 2.
Reverse this procedure to install the fan.
4–56
"Battery" on page
"Hard drive" on page 4-8)
"Memory module" on page
"RTC battery" on page
"WLAN module" on page
"Optical drive" on page
"Keyboard" on page 4-21)
"Keyboard cover" on page
"Speaker assembly" on page
"Display assembly" on page
"Top cover" on page 4-35)
"System board" on page
4-7).
4-10)
4-12)
4-14)
4-20)
4-23)
4-25)
4-27)
4-48)
Spare part number
486844-001
Maintenance and Service Guide