Lithium Battery Caution; Laser Safety Statement; Tv Antenna Connectors Protection - HP s3020n - Pavilion - Slimline Limited Warranty

Limited warranty and support guide
Hide thumbs Also See for s3020n - Pavilion - Slimline:
Table of Contents

Advertisement

WARNING: To reduce the possibility of an electric
shock from the telephone network, plug your
computer into the AC outlet before connecting it
to the telephone line. Also, disconnect the
telephone line before unplugging your computer
from the AC power outlet.
WARNING: Always disconnect the modem cord
from the telephone system before installing or
removing your computer cover.
WARNING: Do not operate the computer with the
cover removed.
WARNING: For your safety, always unplug the
computer from its power source and from any
telecommunications systems (such as telephone
lines), networks, or modems before performing
any service procedures. Failure to do so may
result in personal injury or equipment damage.
Hazardous voltage levels are inside the power
supply and modem of this product.

Lithium Battery Caution

WARNING: The computer uses a lithium battery,
type CR2032. There is danger of an explosion if
the battery is incorrectly replaced. Replace only
with the same, or equivalent, type recommended
by the manufacturer. Dispose of used batteries
according to the manufacturer's instructions.

Laser Safety Statement

Class 1 LED Product
The CD and DVD drives contain a laser system and are
classified as a "Class 1 Laser Product" under a U.S.
Department of Health and Human Services (DHHS)
Radiation Performance standard according to the Radiation
Control for Health and Safety Act of 1968.
Should the unit ever require maintenance, contact an
authorized service location.
14
WARNING: Use of controls, adjustments, or
performance procedures other than those
specified in the Upgrading and Servicing Guide
may result in hazardous radiation exposure. To
prevent direct exposure to laser beam, do not try
to open the enclosure of the CD or DVD drives.
Laser Product Label
The following label or equivalent is located on the surface of
laser products:
Note to CATV System Installer
This reminder is provided to call the CATV systems installer's
attention to section 820-93 of the National Electric Code,
which provides guidelines for proper grounding and in
particular, specifies that the Coaxial cable shield shall be
connected to grounding system of the building, as close to
the point of cable entry as practical.

TV Antenna Connectors Protection

External Television Antenna Grounding
If an outside antenna or cable system is connected to the
product, be sure the antenna or cable system is electrically
grounded so as to provide some protection against voltage
surges and built-up static charges. Article 810 of the
National Electrical Code, ANSI/NFPA 70, provides
information with regard to proper electrical grounding of the
mast and supporting structure, grounding of the lead-in wire
to an antenna-discharge unit, size of grounding conductors,
location of antenna-discharge unit, connection to grounding
electrodes, and requirements for the grounding electrode.
This label indicates that the
product is classified as a
CLASS 1 LASER PRODUCT. This
label appears on a laser device
installed in your product.

Advertisement

Table of Contents
loading

Table of Contents