Password Security - HP Rp5700 - Point of Sale System Reference Manual

Table 4-1 Security Features Overview (continued)
Option
Device Security
Network Service Boot
System IDs
DriveLock (some models)
For more information about Computer Setup, see the Computer Setup (F10) Utility Guide on the Documentation and
Diagnostics CD.
Support for security features may vary depending on the specific computer configuration.

Password Security

The power-on password prevents unauthorized use of the computer by requiring entry of a password
to access applications or data each time the computer is turned on or restarted. The setup password
specifically prevents unauthorized access to Computer Setup, and can also be used as an override to
the power-on password. That is, when prompted for the power-on password, entering the setup
password instead will allow access to the computer.
A network-wide setup password can be established to enable the system administrator to log in to all
network systems to perform maintenance without having to know the power-on password, even if one
has been established.
ENWW
Description
Enables/disables serial ports, parallel port, front USB ports, system audio,
network controllers (some models), and SCSI controllers (some models).
Enables/disables the computer's ability to boot from an operating system
installed on a network server. (Feature available on NIC models only; the
network controller must reside on the PCI bus or be embedded on the system
board.)
Allows you to set:
●
Asset tag (18-byte identifier) and ownership Tag (80-byte identifier
displayed during POST). See the Computer Setup (F10) Utility Guide
on the Documentation and Diagnostics CD for more information.
●
Chassis serial number or Universal Unique Identifier (UUID) number.
The UUID can only be updated if the current chassis serial number is
invalid. (These ID numbers are normally set in the factory and are used
to uniquely identify the system.)
Keyboard locale setting (for example, English or German) for System ID
entry.
Allows you to assign or modify a master or user password for ATA hard drives.
When this feature is enabled, the user is prompted to provide one of the
DriveLock passwords during POST. If neither is successfully entered, the
hard drive will remain inaccessible until one of the passwords is successfully
provided during a subsequent cold-boot sequence.
NOTE: This selection will only appear when at least one ATA drive that
supports the ATA Security command set is attached to the system.
See the Computer Setup (F10) Utility Guide on the Documentation and
Diagnostics CD for more information.
Asset Tracking and Security 41