Replacing The Inner Drawer; Removing The Case - HP Rp3000 - Point of Sale System User Manual

Replacing the Inner Drawer

1. Align the outer slides (mounted to the inner drawer) with the inner slides mounted to the chassis
inside the cash drawer.
2. Lift the inner drawer up until it stops and begin to push the inner drawer into the cash drawer
housing.
3. When the drawer stop on the back of the inner drawer has cleared the stop plate (3) formed from
the base, let the inner drawer rest in the horizontal position.
4. Push the inner drawer to the fully closed position. Expect resistance to the insertion because the
ball bearings do not roll until the slides are fully engaged.
5. When the inner drawer is fully inserted, verify that the drawer opens and closes properly using the
security key. The drawer should open and close smoothly through the full extent of the slides.

Removing the Case

NOTE: It is recommended that the case be removed only in emergencies, such as when the cash
drawer cannot be opened electronically and/or the security key is locked inside the cash drawer.
1. Turn the cash drawer bottom side up with the drawer front opening toward you.
2. Using a #2 Phillips screwdriver, remove the screws securing the base to the case, then slide the
base assembly out towards the front.
3. Remove the till and inner drawer from the cash drawer.
4. Replace the base by reinserting it from the front of the case and under the case side flanges.
Engage the base with the tabs at the rear of the case.
5. Reattach the base and case with the screws. Be sure the drawer front is lined up with the front
edge of the case.
Replacing the Inner Drawer 5