Installing A Drive - IBM NetVista User Manual

The following illustration shows the locations of the drive bays.
The following list describes some of the drives that you can install in each bay and
their height requirements:
1 Bay 1 - Maximum height: 43.0 mm (1.7 in.)
2 Bay 2 - Maximum height: 43.0 mm (1.7 in.)
3 Bay 3 - Maximum height: 25.8 mm (1.0 in.)
4 Bay 4 - Maximum height: 25.8 mm (1.0 in.)
Notes:
1. Drives that are greater than 43.0 mm (1.7 in.) high cannot be installed.
2. Install removable media (tape or CD) drives in the accessible bay (bay 1 or 2).

Installing a drive

To install an internal drive, follow these steps:
1. Remove the cover. See "Removing the cover" on page 39.
2. If your computer has a CD drive or DVD drive, you might need to remove the
signal and power cables from the drive.
3. If the drive you are installing is a removable-media drive, remove the bay
panel from the front bezel.
CD drive or DVD drive (preinstalled in
some models)
5.25-inch hard disk drive
5.25-inch hard disk drive
3.5-inch hard disk drive (requires a
mounting bracket)
CD drive
DVD drive
3.5-inch hard disk drive (preinstalled)
3.5-inch diskette drive (preinstalled)
Chapter 3. Types 8305, 8306, 8309, and 8313
45