Installing A Drive - IBM NetVista User Manual

Installing a drive

To install a CD-ROM drive or DVD-ROM drive in bay 2, follow these steps:
1. Remove the cover (see "Removing the cover" on page 17).
2. If the drive you are installing is a removable-media drive, remove the bay
3. Remove the metal shield from the drive bay by inserting a flat-blade
4. Make sure the drive is set correctly as the master device. Refer to the
5. Pivot the drive bay latch handle toward the front of the computer and then
6. Install the drive into the bay. Align the screw holes and insert the two screws.
24
User Guide
panel from the front bezel.
screwdriver into one of the slots and gently prying it loose.
documentation that comes with your CD-ROM drive or DVD-ROM drive for
master/slave jumper information.
pivot the drive bay cage upward, as shown, until it is latched in the up
position.