Replacing The System Fan Assembly - Lenovo K100 Hardware Replacement Manual

Replacing the system fan assembly

Attention
Do not remove the computer cover or attempt any repair before reading the "Important safety
information" in the Safety and Warranty Guide that was included with your computer or in the Hardware
Maintenance Manual (HMM) for the computer. To obtain copies of the Safety and Warranty Guide or
HMM, go to the Support Web site at http://www.lenovo.com/support.
To replace the system fan assembly:
1. Remove the computer cover. Refer to "Removing the computer cover".
2. Locate the system fan assembly. Refer to "Identifying parts on the system board".
3. Disconnect the system fan assembly cable from the system board. Refer to "Identifying parts on the system
board".
4. Pull the system fan assembly out of chassis.
5. Install the new system fan assembly by aligning the rubber mounts of the system fan assembly with the
holes on the chassis and push the rubber mounts through the holes.
31031416 Greenland HRG_EN.indd 21
21
Hardware Replacement Guide
2007.8.20 4:05:56 PM