Modem Declaration Of Conformity; Canadian Department Of Communications (Cdoc) - Asus S1A Installation Manual

Modem Declaration Of Conformity

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that interference will not occur in a particular instal-
lation. If this equipment does cause harmful interference to radio and television reception, the user is encour-
aged to try to correct the interference by one or more of the following measures:
• Reorient the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is con-
nected.
• Consult the dealer or an experienced radio/TV technician for help.
WARNING! CHANGES OR MODIFICATIONS NOT EXPRESSLY APPROVED BY THE
PARTY RESPONSIBLE FOR COMPLIANCE COULD VOID THE USER'S
AUTHORITY TO OPERATE THE EQUIPMENT

Canadian Department Of Communications (CDOC)

Notice: The Canadian Department of Communications label identifies certified equipment. This
certification means the equipment meets certain telecommunications network requirements.
The Department does not guarantee the equipment will operate to the user's satisfaction.
Before installing this equipment users should ensure that connection to the line is allowed by the local
telecommunications company. The equipment must also be installed using an acceptable method of connec-
tion. In some cases, the company's inside wiring associated with a single line individual service may be
extended by means of a telephone extension cord. Compliance with the above conditions may not prevent
degradation of service in certain situations.
Repairs to certified equipment should be made by an authorized Canadian maintenance facility designated
by the supplier. Any repairs or alterations made by the user to this equipment, or equipment malfunctions,
may give the telecommunications company cause to request the user to disconnect the equipment.
Users should ensure for their own protection that the electrical ground connections of the power utility,
telephone lines, and internal metallic water pipe system, if present, are connected together. This precaution
may be particularly important in rural areas.
WARNING! Users should not attempt to make such connections themselves, but should con-
tact the appropriate electric inspection authority, or electrician, as appropriate.
110