HP Pavilion w1100 - Desktop PC Manual page 11

4 Remove the two screws from the back of the drive
bay and remove the cable (A).
5 Disconnect the power cable and data cable from
the back of the hard disk drive (B). For a Serial ATA
drive, press the latch (1) (select models only) in the
center of each plug and pull the plug (2) from the
drive connector. For a Parallel ATA drive, use a
gentle rocking motion to free the plug.
Disconnecting the Serial ATA hard disk drive
cables
Disconnecting the Parallel ATA hard disk drive
cables
6 Remove the two screws on the front of the
drive bay.
7 Gently pull back and hold the drive bay release
tab while pulling out the drive bay from the front
of the PC.
8 Gently lay the drive bay flat with the hard disk
drive on top.
Upgrading and Servicing Guide
7