Lower Rack - GE GDT550HSDSS Owner's Manual

Gdf510-540 series gdt530-550 series
Hide thumbs Also See for GDT550HSDSS:
Table of Contents

Advertisement

Available languages

Available languages

Clip
Lower Rack - 10 Place Settings - GDF510 & GDF520
Lower Rack - 12 Place Settings - GDF510 & GDF520

Lower Rack

The lower rack is best used for plates, saucers and
cookware items. Large items, such as broiler pans
and baking racks should go along the sides of the
rack. If necessary, oversized glasses and mugs can
be placed in the lower rack to maximize loading
flexibility. Plates, saucers and similar items should be
placed between the tines in the direction that allows
the item to remain secure in the rack.
Do not load large items where they may block the
detergent dispenser when the door is closed.
The reversible tine blocks (on some models) are
designed to allow greater flexibility in loading dishes.
The direction of the tine blocks can be changed to
match preferred loading direction. To adjust the tine
block direction, remove the clips securing the tine
blocks to the racks by pulling up on the tab, then
flex the retaining wire to unseat the tine block from
the lower rack. The tine block may be turned in the
opposite direction to reverse the loading direction.
Secure the tine block to the rack using the same
process and be sure to snap the same clips in place.
WARNING!
choke hazard for small children. Keep out of
reach of children.
Fold down tines (on some models) allow for greater
flexibility in loading large items. Select the position
of the fold down tine that best accommodates
your dishware items. The direction of the fold down
tines can be changed to match preferred loading
direction. To adjust the fold down tine direction,
remove the clips securing the fold down tines to the
racks by sliding the clip so that it disengages from
the rack wire. The fold down tines may be rotated
in the opposite direction to reverse the loading
direction. Secure the fold down tines to the rack
using the same clips. The clip is removed by pulling
up on the clip and separating it from the rack.
Replace the clip on the opposite side of the rack by
positioning the clip over the wire and pressing down.
It is important to ensure that items do not protrude
through the bottom of the rack or the silverware
basket where they will block the rotation of the lower
spray arm. This could result in noise during operation
and/or poor wash performance.
The clips can be a
Lower Rack - 10 Place Settings - GDT530, GDF540 & GDT550
Lower Rack - 12 Place Settings - GDT530, GDF540 & GDT550
GEAppliances.com
9

Hide quick links:

Advertisement

Chapters

Table of Contents
loading

Table of Contents