Use The Operation Buttons - Haier HWM65-728 User Manual

Use the operation buttons

Off
On: indicate the program about to run,or indicate
the selected mode or indicate the water level
Flashing: indicate the running program
During sensing, it displays "--" .
During delay procedure, it displays the
remained delay time (in hours).
During operation of programs,it displays the
remaining time (in minutes).
In case of abnormal phenomenon, it displays
the abnormal symbols (see to Page 15).
The digitron displays the time remained
(in minutes) before the washing is nished.
Push "DELAY" button, the digitron displays
the delay time of washing (in hours). The
indicator flashes to indicate that the delay
function is operating.
Push "DELAY" button to display the delay
mode.
You can choose one or more process
among soak,wash,rinse,spin.
The button is invalid if you choose
"QUICK" or "TUB DRY" program.
You can not choose soak process if
you choose "WOOL" program.
Program Applicable situation
STANDARD Washing the normal laundries
Washing the bigger and heavier laundries
HEAVY
GENTLE Washing the woollen textiles or underwear
Washing the laundries with small quantity
QUICK
and light soil
Washing the blanket
BLANKET
Washing the cotton textiles
COTTON
WOOL Washing the woollen textiles
Drying the inner tub and the outer tub,
TUB DRY
which can avoid growing mildew
Push the "POWER ON/OFF" button to
switch on the power.
When the power is on, push it again to
switch off the power.
Push the "POWER ON/OFF" button to
switch on the power.If the "START/PAUSE"
button is not pushed, the washing machine
will automatically switch off the power
after 5 minutes.
After the power is switched on,press it to start
the machine.
During working, push it to pause.
During pause, push this button to restart
and go on working
RESERVE(HOURS)
BLANKET
STANDARD
SOAK
COTTEN
HEAVY
WASH
GENTLE WOOL
RINSE
QUICK TUB DRY
SPIN
PROCESS
During the standard program,the washing
machine can detect the laundries automatically.
After detection,it will set the water level to
suitable value automatically among the water
level "LOW","MEDIUM","HIGH" and "MAXIMUM".
You can also set water level by yourself.After the
machine is started, it will not set water level
automatically. You shall push the "START/PAUSE"
button to make new setting.
If there's water inside the tub, the machine can
not detect the laundries and will display water
level "MEDIUM" .If wet laundries are put in, it
may display water level "MAXIMUM".You must
set suitable water level by yourself.
If QUICK program is selected, it will display water
level "LOW",the water level can not be adjusted.
If TUB DRY program is selected, the water level
will not respond.
During operation of wash , rinse and soak
program, you can push down the water level
button to add water. When you release the
button, or it reaches the over ow water level,
the machine will stop adding water.
The water level decided may be different from
actual value because of the different moisture
level of the laundries.
MAXIMUM
HIGH
MEDIUM
LOW
POWER
EXTRA LOW
ON/OFF
11