Listening Through A Receiver (Home Theater); Check Points Before Requesting Service - Samsung LN-T2354H - 23" LCD TV Owner's Instructions Manual

listening through a receiver (home theater)

You can listen to sound through a receiver instead of the TV speaker.
. Press the anynet+ button.
Press the ▲ or ▼ button to select Receiver, then press the EntEr button.
. Press the ◄ or ► button to select to On, then press the EntEr button.
Now you can listen to sound through the receiver.
. Press the ExIt button to exit.
➢
When the receiver is set to On, you can listen to the TV sound through the 2-channel receiver.
➢
If the receiver is exclusively for a home theater only (supporting audio only), it may not appear in the
device list.
➢
Only when you have connected the optical jack of the TV and the receiver properly, does Receiver work.
➢
In case of a content with copyright problem, listening through the receiver may not properly operate.

Check points before requesting Service

Symptom
anynet+ does not work.
I want to start anynet+.
I want to exit anynet+.
the Connecting to anynet+
device... message appears on the
screen.
the anynet+ device does not play. You cannot use the play function when an auto channel scan is in progress or in
the connected device is not
displayed.
Solution
■ Check if the device is an Anynet+ device. The Anynet+ system supports Anynet+
devices only.
■ Connect only one receiver (home theater).
■ Check if the Anynet+ device power cord is properly connected.
■ Check the Anynet+ device's Video/Audio/HDMI Cable connections.
■ Check whether the TV remote control is in TV mode.
■ Check whether it is Anynet+ exclusive remote control.
■ Anynet+ doesn't work at a certain condition. (Searching channels, Operating
WISELINK)
■ Check if the Anynet+ device is properly connected to the TV and check if the Anynet+
(HDMI-CEC) is set to On in the Anynet+ Setup menu.
■ Press the tV button on the TV remote control to switch to TV. Then press the
anynet+ button to show the Anynet+ menu and select a menu you want.
■ Select Watch tV in Anynet+ menu.
■ Press the SourCE button on the TV remote control and select a device other than
Anynet+ devices.
■ Press Ch, Ch lISt, prE-Ch, etc. to change to the TV mode. (Note that the channel
button operates only when a tuner-embedded Anynet+ device is not connected.)
■ You cannot use the remote control when you are configuring Anynet+ or switching to a
view mode.
■ Use the remote control when the Anynet+ setting or switching to view mode is
complete.
WISELINK mode. Stop the currently running function.
■ Check whether or not the device supports Anynet+ functions.
■ Check whether or not the HDMI Cable is properly connected.
■ Check whether HDMI Control is set to On in the Anynet+ setup menu.
■ Search Anynet+ devices again.
■ You can connect an Anynet+ device using the HDMI Cable only. Some HDMI cables
may not support Anynet+ functions.
English - 
air 
recevier: on
Connect recorder
Setup
move Enter Exit