Related Service Information; Service Web Site; Restoring The Factory Contents By Using Product Recovery Discs - Lenovo 195143U Hardware Maintenance Manual

Related service information

This section provides information about the following:
v "Service Web site"
v "Restoring the factory contents by using Product Recovery discs"
v "Passwords" on page 26
v "Power management" on page 28

Service Web site

When the latest maintenance diskette and the system program service diskette
become available, they will be posted on http://www.lenovo.com/spm
Restoring the factory contents by using Product Recovery
discs
When the hard disk drive is replaced because of a failure, no Product Recovery
program is on the new hard disk. In this case, you must use the recovery discs for
the computer. Order the recovery discs and the hard disk drive at the same time so
that you can recover the new hard disk drive with the pre-installed software when
they arrive. For information on which discs to order, see "Recovery discs" on page
205.
To install the factory contents by using Product Recovery discs, do the following:
1. Insert the Rescue and Recovery
2. When the "Welcome to Rescue and Recovery" screen is displayed, press
3. "Restore Your System" window appears. Select Restore my hard drive to the
4. The Terms and Conditions window appears, select I accept these terms and
5. You will then be prompted to insert Product Recovery Disk 1 into the optical
6. After all the files are copied, the computer will restart and return to the
Note
Recovery takes several hours. The length of time depends on the method you
use. If you use recovery discs, recovery takes at least five hours.
the computer. This will take several minutes.
Continue. In the Rescue and Recovery menu, select Restore Your System. A
message giving a warning that USB devices used in recovery must be
connected when the computer is turned on appears. Click OK.
original factory state, and click Next. A warning appears, click Yes. Then next
menu appears. Select I do not want to save any files and click Next. Following
menu appears with a warning, select Next. A warning appears not to power
down the computer during the recovery process. Click OK. One more warning
appears saying that recovery is intended only for unrecoverable system
problems. Click OK.
conditions and press OK. Previous menus may remain on the screen, but the
Predesktop installer begins copying files. When this completes, the computer
will restart and a window will ask you to insert a Product Recovery
Supplemental Disk, if you have one. Press No.
drive. Insert the Product Recovery Disk 1 into the optical drive, and press OK.
In similar fashion, you will be prompted to insert the remaining recovery discs
until all the files are copied.
"Welcome to Rescue and Recovery" screen where a window "Recovering your
system, this may take several minutes" appears and .IMZ files are processed.
Related service information
®
Disk1 of 1 into the optical drive, then restart
25
General descriptions