Setting Your Changes As The New Default; Restoring All Settings To The Factory Settings; Scan To A Memory Card Or Usb Flash Memory Drive; Entering Scan Mode - Brother DCP-395CN User Manual

PhotoCapture Center
Setting your changes as the
new default
You can save the print settings you use most
often by setting them as the default settings.
These settings will stay until you change
them again.
a
Press a or b to choose your new setting.
Press OK.
Repeat this step for each setting you
want to change.
b
After changing the last setting, press a
or b to choose Set New Default.
Press OK.
c
Press + to choose Yes.
d
Press Stop/Exit.
Restoring all settings to the
factory settings
You can restore all the settings you have
changed to the factory settings. These
settings will stay until you change them again.
a
Press a or b to choose
Factory Reset.
Press OK.
b
Press + to choose Yes.
c
Press Stop/Exit.
®
: Printing photos from a memory card or USB Flash memory drive
Scan to a memory card
or USB Flash memory
5
drive

Entering Scan mode

When you want to scan to a memory card or
USB Flash memory drive, press
The LCD shows:
SCAN
Press a or b to choose Scan to Media.
Press OK.
If you are not connected to your computer
only the Scan to Media selection will appear
5
on the LCD.
(See Using the Scan key in the Software
User's Guide on the CD-ROM for details
about the other menu options.)
Scan to E-mail Scan to E-mail
Scan a document Scan a document
Scan to Image Scan to Image
directly to a media directly to a media
Scan to OCR Scan to OCR
card or USB card or USB
Scan to File Scan to File
flash flash
Scan to Media Scan to Media
memory. memory.
5
5
(Scan).
5
Select & Press OK
53