Table of Contents
Advertisement
5. Using the Scanner Function
• When the machine's default for the same setting is changed.
• For details about [Scan Size], see p.255 "Scanner Settings".
• For details about [System Auto Reset Timer], see p.291 "Administrator Settings".
Adjusting image density
This section describes how to adjust image density for the current job.
There are five image density levels. The higher the density level, the darker the scanned image.
1.
Press the [Density] key.
2.
Press the [ ][ ] keys to select the desired density level, and then press the [OK] key.
• Press the [Escape] key to discard the current change and return to the initial screen.
• You can change the machine's default [Density] setting to always scan with a specific density level.
• Temporary job settings are cleared in the following cases:
• When no input is received for the period of time specified in [System Auto Reset Timer] while
the initial screen is displayed.
• When the [Clear/Stop] key is pressed while the initial screen is displayed.
• When the machine's mode is changed.
• When the power is turned off.
• When the machine's default for the same setting is changed.
• For details about [Density], see p.255 "Scanner Settings".
• For details about [System Auto Reset Timer], see p.291 "Administrator Settings".
188
CES178
Advertisement
Table of Contents
