Advertisement
YM-460/460F/410/410F/46/41
ASSEMBLY
1-2. YM-460/460F/46: Connect the reinforcement stays at the center. Align the end of the fixing bolt and
the holes in the reinforcement stays and tighten the fixing bolt securely.
* Insert the support using the reference hole close to the hole for the screw as a guide.
Reinforcement stay
(Large end)
1-3. Insert the reinforcement stay with its notch facing up into the lower joint of the large end leg as far as
it will go (aligning the notch with the fixing bolt) and tighten the fixing bolt securely.
(A mark "E" is printed on the reinforcement stay and the large end joint.)
Fixing bolt
Leg
1-4. In the same way, install the reinforcement stay to the small end leg.
(There is no marking on the small end joint.)
28
Screw hole
Reinforcement
stay
Notch
Reference hole
Leg (Large end)
Reinforcement stay
Reinforcement stay
(Small end)
Tighten
Fixing bolt
Notch
Advertisement
