Cleaning The Pre-Motor Filter - Bissell PowerGroom Multi Cyclonic Canister User Manual

M
aintenance and care

Cleaning the pre-motor filter

The pre-motor filter protects the
motor from dirt and dust particles.
Use only BISSELL replacement filters
in your PowerGroom Multi Cyclonic.
1. Turn the power OFF. Unplug the
vacuum from the electrical outlet.
2. Remove the dirt container from
the vacuum.
3. The pre-motor filter is located behind
the door labeled "FILTER" on the main
body of the vacuum. Open the door by
pushing up on the tab at the bottom of
the door and pulling out to remove.
4. Remove the filter tray by pulling up
on the tab of the tray. Remove the
pre-motor filter and set aside. Tap the
tray gently over a trash can to remove
any dirt or debris.
5. The pre-motor filter can be washed in
cold water with a mild detergent. Rinse
well and air dry thoroughly before
placing back into the tray.
6. Place the tray back into the vacuum
and replace the filter door by inserting
the tabs at the top of the door and
pushing down until it clicks into the
locked position.
w w w . b i s s e l l . c o m
NOTICE:
This product is intended for household
use only and not for commercial or
industrial use. Vacuuming of dust
from products like plaster, concrete
or ashes will damage the motor and
void the warranty.
4.
4.
Filter Tray
Tip:
For maximum cleaning
performance, check the
filters often and clean or
replace if necessary.
WARNING:
Do not operate cleaner with
damp or wet filters or
without all filters in place.
8 0 0 . 2 3 7 . 7 6 9 1
Pre-Motor Filter
11