Play Back The Recorded Performance; Play] Button - Yamaha P-95S Owner's Manual

Recording Your Performance
4.
Press either [REC] or [PLAY] button to stop record-
ing.
When recording is stopped, the
cate that the recorded data is being saved to the instrument automatically. After
the data is saved, the
NOTICE
Do not turn off the power of the instrument when the lamps are flashing. Doing so
may prevent saving of the song data which you have recorded.
The user song recorder records the following data:
Data in addition to the notes and voices you play is recorded.
• Notes played
• Voice selection
• Pedal (Sustain/Soft/Sostenuto)
• Reverb depth
• Dual mode voices
• Dual balance
• Dual octave shift
• Tempo
• Reverb type (including OFF)

Play back the recorded performance

Press the
[PLAY]
back in the middle of a song, press the
While holding down the
tons to change the playback tempo.
22
P-95 Owner's Manual
lamp and the
[REC]
lamp will turn off and the
[REC]
button to play back the recorded performance. To stop play-
[PLAY]
button, use the
[METRONOME]
lamp flash to indi-
[PLAY]
lamp will light.
[PLAY]
button again.
TEMPO [ g g g g ]/[ h h h h ]
NOTE
Both the [REC] lamp and the
[PLAY] lamp will begin to flash
when the recorder memory is
almost full. If the memory
becomes full, recording will stop
automatically. (All recorded data
up to that point will be retained.)
NOTE
You can save the recorded data
to a computer. You can also load
the recorded data back from a
computer and play it back on this
instrument (page 25).
NOTE
Pressing the [REC] button to start
recording, then pressing the
[PLAY] button to stop recording
will erase all previously- recorded
data.
NOTE
You cannot re-record in the mid-
dle of a song.
but-