Gigabyte GA-890XA-UD3 User Manual page 48

Onboard GSATA/IDE Ctrl Mode (GIGABYTE SATA2 Chip, GSATA2_6/7 Connectors)
Enables or disables RAID for the SATA controller integrated in the GIGABYTE SATA2 chip or configures
the SATA controller to AHCI mode.
IDE
AHCI
RAID/IDE
Onboard ESATA Controller (JMicron JMB362 Chip, eSATA Connectors)
Enables or disables the SATA controller integrated in the JMicron JMB362 chip. (Default: Enabled)
Onboard ESATA Mode (JMicron JMB362 Chip, eSATA Connectors)
Enables or disables RAID for the SATA controller integrated in the JMicron JMB362 chip or configures
the SATA controller to AHCI mode.
IDE
AHCI
RAID
Onboard LAN Function
Enables or disables the onboard LAN function. (Default: Enabled)
If you wish to install a 3rd party add-in network card instead of using the onboard LAN, set this item to
Disabled.
Onboard LAN Boot ROM
Allows you to decide whether to activate the boot ROM integrated with the onboard LAN chip.
(Default: Disabled)
SMART LAN (LAN Cable Diagnostic Function)
Start detecting at Port.....
Part1-2 Status = Open / Length =
Part3-6 Status = Open / Length =
Part4-5 Status = Open / Length =
Part7-8 Status = Open / Length =
higf : Move Enter: Select
F5: Previous Values
This motherboard incorporates cable diagnostic feature designed to detect the status of the attached LAN
cable. This feature will detect cabling issue and report the approximate distance to the fault or short. Refer to
the following information for diagnosing your LAN cable:
When No LAN Cable Is Attached...
If no LAN cable is attached to the motherboard, the Status fields of all four pairs of wires will show Open
and the Length fields show 0m, as shown in the figure above.
BIOS Setup
Configures the SATA controller to IDE mode. (Default)
Configures the SATA controller to AHCI mode. Advanced Host Controller Interface
(AHCI) is an interface specification that allows the storage driver to enable advanced
Serial ATA features such as Native Command Queuing and hot plug.
Enables RAID for the SATA controller; the IDE controller still operates in IDE mode.
Disables RAID for the SATA controller and configures the SATA controller to IDE
mode. (Default)
Configures the SATA controller to AHCI mode. Advanced Host Controller Interface
(AHCI) is an interface specification that allows the storage driver to enable advanced
Serial ATA features such as Native Command Queuing and hot plug.
Enables RAID for the SATA controller.
CMOS Setup Utility-Copyright (C) 1984-2010 Award Software
0m
0m
0m
0m
+/-/PU/PD: Value
F6: Fail-Safe Defaults
SMART LAN
F10: Save
- 48 -
Item Help
Menu Level 
ESC: Exit F1: General Help
F7: Optimized Defaults